Vehicles
Sections
418 not categorized PORSCHE 914 RETURNCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 928 1983-86 (includes uncategorized and accessory items) RES99701061S Race headers 997 GT3 cup, stainless steel - + 10 crank hp & + 8 crank torque - total weight is 14.1 lbs. (6,4 kg) FVD is proud to introduce our newest line of Brombacherrace exhaust systems. Brombacher race exhausts are engineered for the discerning Porsche owner and offer unmatched performance, unparalleled quality, and incredible value. All of our exhausts are manufactured in Germany and are tested comprehensively for flow rate characteristics, thermal stress, resistance to cracking, and longevity. To further ensure quality, this race system meet's the standards of the fia and is registered with them directly. In addition, Brombacherrace exhausts systems are available for ultimate performance full titanium...(choose a part on the right to read more)
From $2,985.40
Make a selection FVD51154199 Prevents the hood from accidentally opening at speed and keeps the hood in place should an impact occur. These are genuine Porsche motorsports parts from Germany. Fits front hood / trunk and or the rear deck lid. Sold individually. All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$92.40
Make a selection RES987202TH1OK The heat reduction for exhaust systems with thermal insulation come first in motor sport. By reducing the heat buildup under the vehicle and in the engine compartment cooler air intake temperatures are reached which leads to a noticeable performance increase. Vehicles with increased power produce also higher exhaust temperatures. Exhaust systems with thermal insulation also protected adjacent components from these temperatures. Benefits for thermal insulation: - performance improvement - increasing the efficiency of the engine - cooler air intake - reduce the heat buildup under the vehicle - reduction of fuel consumption - faster response for catalysts (shorter heat cycle) - temperature resistance more than 110...(choose a part on the right to read more)
$1,183.60
Make a selection FVD51299122MM The moshammer vented rear diffuser with fins is an aggressive design that reduces aerodynamic drag. This vented diffuser allows air that is trapped by the rear bumper to exit, allowing for greater top end performance. The design also incorporates 5 fins that improve laminar airflow by reducing turbulence. Moshammer manufactured this as a direct replacement, so it secures seamlessly to the factory locations with the original hardware. This is an ideal addition for a leased vehicle or for those looking to return the car to its original appearance in the future. When added to other elements of the evo rs (991.2 turbo/s) package, the result is a confident, cohesive stance with balanced downforce. Features: vented f...(choose a part on the right to read more)
$1,844.70
Make a selection FVD51299124MM The moshammer stormforce evo rs rear spoiler for the 991.2 model blends a bit of Porsche ducktail heritage into its design to increase rear downforce and reduce front axle uplift. The contours of this spoiler have a step effect which seamlessly blends into both rear quarter panels. When viewed at a standstill it has a subtle factory like appeal that complements the cars lines. When deployed the rake angle takes on a more aggressive appearance evoking thoughts of the much beloved ducktails. Like a majority of the moshammer offerings, this spoiler is a direct replacement, so it secures seamlessly to the factory locations with the original hardware. This is an ideal addition for a leased vehicle or for those looki...(choose a part on the right to read more)
$1,455.30
Make a selection HR5507 If you have room in your fender well to spacer your wheels out, here is an easy way to improve your Porsche’s handling. Made of aluminum/magnesium alloy these hard anodized spacers are hub-centric and up to 70% lighter than typical steel wheel spacers. Made in Germany. Spacers come with wheel bolts, studs and nuts. General Fitment911 1994-98911 1989-94 911 1987-89 911 1984-86 911 1978-83 930 1975-77 911 1974-77 911 1970-73 911 1965-69 968 1992-95 944 1989-91 944 1985-88 944 1982-85 924 1986-88 924 1980-85 912 1965-69 928 1992-95 928 1987-91 928 1983-86 928 1978-82 356 1960-65
$225.00
Make a selection FVD33104381 The tow link is the furthest rear control arm on the rear axle. It is responsible for the toe angle adjustment. The OEM control arm bushings are simply too soft for track events and the teflon monoball racing bushings are too far too hard and noisy for street cars. Our sport bushings are made of a denser rubber (85 shore opposed to OEM 65 shore), which means that they are suitable for street and track use. Equally as important is that they do not produce any noise like the teflon bushings. FVD sport control arm facts: - better handling and more responsive. - makes precision adjustments of the suspension easier. - does not produce noise. - shore a hardness value of 85 for durability and handling. - fit's like o...(choose a part on the right to read more)
$482.89
Make a selection FVD33391100SET Replace worn-out original spring plate bushings to return your car to its intended ride quality and performance. This is a high-quality OEM 65 shore density bushing set, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. This set is a direct replacement for original part # 911 333 009 00 sold as a set. 1 necessary per axle.
$108.90
Make a selection 99634307092 All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$181.50
Make a selection FVD33394401SET Replace worn-out original spring plate bushings to return your car to its intended ride quality and performance. This is a high-quality OEM 65 shore density bushing set, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. This set is a direct replacement for the rear axle strut bushings from original part # 477 511 201 and 477 511 202 sold as a set. 1 necessary per axle.
$108.90
Make a selection FVD123019ATK Our k24 sport turbocharger is based off the optional k24 turbochargers, found in the GT2 or 993 turbo x50 models. They are remanufactured by borg warner certified technicians in Germany and are a cost-effective solution. The remanufacturing process includes full inspection of the turbocharger to ensure proper operation after the remanufacturing process. We then disassemble, clean and degrease the unit. The compressor wheels are exchanged, lightened and modified for more air flow. All clearances / shaft tolerances are checked for precision to ensure reliability. The end result is 20-30 additional horsepower, in the low and mid rpm range over the factory turbo. The sport turbo also has less lag than a factory k24...(choose a part on the right to read more)
$2,042.70
Make a selection 99734728591 All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$727.10
Make a selection FVD34101702RAK Unsure about installing replacement bushings and bearings? Send us your control arm and we will properly recondition and install the bushings and bearings for you. The reconditioning process includes full inspection of your track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we will properly install our FVD race front control arm bushings. They are made with uniball bearings so suspension motion is accurately repeated in every corner. Please note: each control arm is remanufactured in Germany, so the lead times can vary. If we cannot remanufacture your control arm we will notify you as soon as we can. Arrange...(choose a part on the right to read more)
$438.90
Make a selection FVD34101702RAT We will send you a reconditioned control arm, kindly send back your old part, or core . The reconditioned control arm has been full inspected, disassembled, degreased and we have properly installed FVD race front control arm bushings. They are made with uniball bearings so suspension motion is accurately repeated in every corner. Please note: each control arm is remanufactured in Germany, so the lead times can vary. This part is sold on an exchange basis, as such an additional charge (a core deposit) will be added to the purchase price of the part. After receiving your new part, kindly send back your old part, or core . Once the core is returned to us and it has been inspected to ensure it is rebuild-able and r...(choose a part on the right to read more)
$440.00
Make a selection 9963514089C All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$982.30
Make a selection 99663114380 Please note: this is for cup / r models up to 2001. They have the cut out for the clear headlight corner trim. All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$335.50
Make a selection 9966310639A All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$225.50
Make a selection 99334101802ATK Unsure about installing replacement bushings and bearings? Send us your control arm and we will properly recondition and install the bushings and bearings for you. The reconditioning process includes full inspection of your track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we will properly install original control arm bushings. . Please note: each control arm is remanufactured in Germany, so the lead times can vary. If we cannot remanufacture your control arm we will notify you as soon as we can. Arrangements can be made for its return to you. We do not offer a core exchange on this part. Sold individually....(choose a part on the right to read more)
$418.00
Make a selection 9963524359A All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$850.30
Make a selection 99630091390 All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$169.40
Make a selection 99610090391 All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$808.50
Make a selection 99611602775 All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
From $455.58
Make a selection 99711013190 All motorsport and racing parts are special order items. Special order items must be paid for in advance. Special order items are sold on a non-cancelable, non-exchangeable, non-returnable, non-refundable basis and do not carry any warranty. No exceptions.
$337.70
Make a selection 91134101310ATK The reconditioning process includes full inspection of the cross member to ensure proper operation after the remanufacturing process. We then disassemble, degrease and media blast the part. Once fully prepared, we seal it with a corrosion resistant plating. Send us your cross member and we will have it reconditioned for you. We do not offer a core exchange on this part. If your original part is defective and cannot be salvaged, we will notify you and make arrangements for its return. Sold individually. 1 necessary per car.
$297.00
Make a selection 911110967XATK This part is a genuine remanufactured part sourced from Porsche ag in Germany. It replaces original part # 911 110 967 00. We sell this item on an exchange basis with a core charge. An additional charge (a core deposit) will be added to the purchase price of the part. After receiving your new part, kindly send back your old part, or core . Once the core is returned to us and it has been inspected to ensure it is rebuild-able and resell-able, the core deposit will be refunded. Sold individually. 1 necessary per car. Please note: please check the model fitment tab to ensure accurate fitment.
$2,385.90
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |